Features & Specs
Solar Cell Sorting & Cutting
Solar Cell Sorting Device
It is used classify and sort out mono crystalline and multi crystalline silicon solar cells. Solar cell’s electrical properties are measured by simulating solar spectrum.
Effective Inspection Area | 300 x 300 mm |
Light Source | HID |
Light Intensity | 70~120 mW/cm2) |
Light Intensity Uniformity | ≤ ± 3% |
Testing Time | 3 sec/pc |
Data Collection | 8000 |
Testing System | PC with Window, A/D Control Card, Display I-V & P Curves |
Testing Parameters | Isc / Voc / Pm / Vm / Im / FF / EFF |
Testing Condition Calibration | Automatic (Includes Compensation Parameters Input, Temperature Compensation & Light Intensity Compensation) |
Voltage | 220V / Single Phase / 50Hz |
Laser Scribing & Cutting Machine
Solar cells usually come in standard sizes which are ready for solar modules production. However, if necessary, solar cell and wafer could be cut into smaller sizes with laser scribing and cutting machine. This machine is applicable for mono-crystalline, multi-crystalline and amorphous solar cells.
Working Table Size | 350 × 350mm |
Laser Wavelength | 1.064μm |
Laser Output | ≥ 50W |
Laser Repeated Frequency | 200Hz ~ 50kHz |
Scribing Line Width | ≤ 30μm |
Max. Scribing Speed | 140 mm/s |
Scribing Accuracy | ≤ ±10μm |
Working Table | Vacuum with 2 Stations for Changeable of Work Piece |
Cooling | Re-Circulated Constant Temperature Water Cooling |
Voltage | 380V (220V) / 50Hz / 5kVA |