EVA Interlayer for Encapsulation of Photovoltaic Solar Panel

Process

General

  • The film is a little under tension when roll winding up during production. Cutting approximately 3% more in length and width is required.
  • When it is the first time to use a new type of EVA film or from a new supplier, it is recommended to carry out testing, before mass production, until the most optimum processing parameters are obtained.
  • No hard pull on film to prevent from distortion.
  • No direct film contact with bare hand to prevent from reducing viscidity
  • Keep away from moisture
  • Used up within 48 hours after unpack
  • During cutting and assembly, it is recommended to get rid of electrostatic which accumulated in solar modules

One Step

Two Steps