Photovoltaic EVA Encapsulation Film Production Line

Features


  • Design to Produce EVA Encapsulation Film for Photovoltaic Panel Manufacturer
  • Raw Materials are Thoroughly Blended and Mix with Durable Extruding Screw
  • Extruding Screw is Made of Anti-Abrasive & Ultra Hard 38CrMoALA High Quality Structural Alloy Covered with Nitride Treated Surface
  • Materials are Heated Up by Means of Ceramic
  • Ceramic Heating Provides Uniform Heating with Better Insulation, Higher Mechanical Strength, Anti-Corrosive & Anti-Electromagnetic Interference & Lasts Longer
  • Extruder is Equipped with Special Designed Gear Reductor with Super Hard Gears
  • Gear Box is Cooled Down by Water Recirculation System
  • High Torque Direct Current Driving Motor is Equipped with Direct Current Controller
  • Pressure Transducer Monitors Real Time Pressure
  • Hydraulic System with Replaceable Net Filter
  • Special Design Extruding Die
  • Emboss Roll Carves Pattern on EVA Film Surface
  • Emboss Figure could be Standard or Custom Made
  • EVA Film Thickness Measuring Device for Real Time Monitor
  • Swinging System Ensures Uniform & Consistent EVA Film Tension & Flatness During Roll Up
  • Annealing System Guarantees Proper EVA Film Shrinkage Rate
  • Cutting System to Split Film into Two or More Portions of Film with Less Width
  • Two-Sides Scrap Cutting Device to Remove Unused Film Edges
  • Special Design Winding Up System for EVA Rolls Changeover Free of Adhesive Tape which Causes Film Yellowish