Features
IG-SBB-FA
Introduction
IG-SBB-FA Bends Spacers In Almost Any Frame Shapes Automatically
It is fast, precise and easy. Almost any shapes could be bent from this highly automatic machine.
Highlights
- IG-SBB-FA can bend almost any shapes.
- All bending within the frame is done automatically and continuously.
- Spacer bars are connected automatically one after one by means of straight connectors.
- This intelligent bending machine can avoid bending at connectors.
- Sophisticated bending tool and support rollers allow spacer bending corners in perfect shape and good looking. Corners are dimensionally stable and are non-distorted.
- Thanks to advanced cutting tool and technology, no burr or chip are found on cutting edges. It does not affect joint quality between spacer bars. This bending machine can also act as cutting machine in case necessary.
- Spacer feeding speed is adjustable.
- Bending could be done manually. This is especially useful during maintenance.
- All settings and operations are achieved from HMI touch panel display except power on and off.
- All operation is done automatically except spacer bar loading in magazine and unloading of bent spacer frame.
Structure
It Consists of Loading Magazine Rack, Incline Table, Bending System, Cutting & Control System
Spacer bars are loaded in magazine rack. Incline table is a structure where spacer bars are bent and lean. Bending system is composed of bending tools, support rollers and pneumatic system. Cutting system includes motorized cutting blade to cut spacer bar instantaneously. Control system is used to control the complete automatic and frame data transfer and storage.
Procedure
All Operations Of IG-SBB-FA Are Done Fully Automatically
- Spacer bars, with one end already inserted with metal straight connector, are loaded on magazine rack.
- Each piece of spacer bar is feed into incline table automatically. Spacer lengths of each bending are already pre-set in control system. During feeding, spacer stops automatically when it arrives at set length.
- Bending tool begins to work. After first bending, spacer starts to feed automatically again until it arrives at next set length. Second bending begins to work. This is repeated until spacer frame is form.
- When bending is completed, spacer is cut into exact length automatically. One end of spacer is already inserted with a straight connector. Operator is required to insert the connector to the other end. A complete spacer frame is then achieved.
- Spacer begins to feed to the machine again and the cycle is repeated. When each piece of spacer bar comes to an end, next piece of spacer bar is feed from magazine. Front end of subsequent spacer is connected automatically to the tail end of prior spacer by means of straight connector. It minimizes spacer wastage and meanwhile, this continuous feeding of spacer ensures non-stop of spacer supply.
